![background image](http://html.mh-extra.com/html/ryobi/ts1300/ts1300_operators-manual_1506647008.webp)
Page 8
R
O
T
A
T
IO
N
R
O
T
A
T
IO
N
IN
S
Fig. 1
Your Miter Saw has been shipped completely assembled
except for the blade, miter lock handle, dust guide or dust
bag, work clamp, table extensions, and stop block.
■
Remove all loose parts from the carton. Separate and
check with the list of Loose Parts.
See Figure 1.
■
Remove the packing materials from around your saw.
■
Carefully lift saw from the carton and place it on a level
work surface. Although small, this saw is heavy. To avoid
back injury, get help when needed.
■
Do not discard the packing materials until you have
carefully inspected the saw, identified all loose parts, and
satisfactorily operated your new saw.
■
Your saw has been shipped with the saw arm locked in
the down position. To release saw arm, push down on top
of saw arm and pull out the lock pin.
See Figure 3.
■
Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the lock pin.
■
Examine all parts to make sure no breakage or damage
has occurred during shipping.
If any parts are damaged or missing, do not attempt to plug
in the power cord and turn the switch on until the damaged
or missing parts are obtained and are installed correctly.
Contact your nearest Ryobi dealer or call 1-800-525-2579 in
the United States or 1-800-265-6778 in Canada for assistance
if any parts are missing or damaged.
WARNING:
If any parts are missing do not operate your saw until the
missing parts are replaced. Failure to do so could result
in possible serious injury.
LOOSE PARTS LIST
The following items are included with your Miter Saw:
■
10 in. (254 mm) Carbide Tipped Blade
■
Miter Lock Handle
■
Dust Guide
■
Blade Wrench
■
5 mm Hex Key
■
6 mm Hex Key
■
8 mm Hex Key
■
Operator's Manual
■
Warranty Registration
Some models may include one or more of the following
accessories:
■
Work Clamp
■
8 mm Work Clamp Screw
■
Dust Bag
■
Stop Block
■
Table Extensions (2)
■
Small Wing Screw (for use with stop block)
■
Large Wing Screws (2), for use with table extensions)
5 mm HEX KEY
8 mm HEX KEY
WORK CLAMP
SAW BLADE
MITER
LOCK HANDLE
BLADE WRENCH
8 mm WORK
CLAMP SCREW
UNPACKING AND CHECKING CONTENTS
SMALL WING
SCREW
STOP BLOCK
LARGE WING
SCREWS
DUST GUIDE
TABLE EXTENSIONS
DUST BAG
6 mm HEX KEY