Ryobi RYRM8001, Инструкция по сборке

Страница: 4 / 28

4 — English
UNPACKING

Remove the bolts securing the corner and side braces
to the frame bottom, then lift the braces to remove.
 Cut the nylon straps securing the front and rear wheel
axles to the frame.

Remove boxes containing loose parts, assembly hardware,
and documentation.
 Remove and set aside all accessible packaging and wrap
from unit and parts. Do not discard the packing material
until you have carefully inspected and satisfactorily oper-
ated the product.
WARNING:
If any parts on the Loose Parts List are already assembled
to your product when you unpack it, verify the part is
assembled correctly, is properly tightened, and is torqued
correctly (where applicable) before proceeding to the next
assembly step. Use of a product that may have been
improperly assembled could result in death or serious
personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.

If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
NOTE: Mower should be assembled while positioned on
the frame bottom. Once assembly is complete, raise the
cutting deck to its highest position, position a ramp next to
the frame bottom, release the parking brake and slowly and
carefully drive mower off frame.
WARNING:
Use extra care when driving the mower off of the frame.
Press the low speed drive button and carefully move the
joystick and/or press the brake pedal as needed to con-
trol the speed. When driving the mower off of the frame,
do not exceed the maximum recommended operation
angle of 15°. Failure to follow these instructions can result
in loss of control and result in death, serious personal
injury, or property damage.
NOTICE:
If no ramp is available, slowly and carefully drive the
mower off the frame in reverse while looking down and
behind. Driving the mower off the frame in the forward
direction without a ramp can cause damage to the
mower’s cutting deck.