![background image](http://html1.mh-extra.com/html/ryobi/ry6202/ry6202_operators-manual_1505970009.webp)
Page 9
Fig. 2
IMPORTANT CHARGER INFORMATION
The battery pack for this Circular Saw, should be charged
only with charger provided. The charger part number will
be found on a plate located on the bottom of the charger.
Before using the charger, it is extremely important that you
familarize yourself with the LED functions of the charger.
See Figure 2 .
LED FUNCTION OF CHARGER
See Figure 2.
LED WILL BE LIGHTED TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
■
Red LED lighted = Fast Charging Mode
■
Green LED lighted = Fully Charged Battery Pack
■
Yellow and Green LED Lighted = Control Charge or
Defective Battery Pack.
CHARGING BATTERY PACK
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it prior to use.
NOTE:
Batteries will not reach full charge the first time they
are charged. Allow several cycles (cutting followed by re-
charging) for them to fully charge.
TO CHARGE
■
Charge battery pack only with the charger provided.
■
Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only.
■
Connect charger to power supply.
■
Place battery pack in charger.
See Figure 3.
Align raised
rib on battery pack with groove in charger.
■
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
■
Normally, the yellow and green lights on the charger will
come on. This indicates charger is in control charge
mode and should switch to fast charge mode within 5
minutes. When charger is in fast charge mode the red
light will come on. If after a period of 15 minutes the
yellow and green lights remain on, remove the battery
pack, wait 1 minute and reinsert battery pack in charger.
If the yellow and green lights continue to remain on an
additional 15 minutes, the battery pack is damaged and
will not accept charge.
■
When your battery pack becomes fully charged, the red
light will turn off and the green light will turn on.
■
After normal usage, 1 hour of charge time is required to
be fully charged. A minimum charge time of 1 to 1-1/2
hours is required to recharge a completely discharged
tool.
BATTERY
CHARGER
GREEN LIGHT "ON"
INDICATES FULLY
CHARGED
YELLOW AND GREEN LIGHTS "ON"
INDICATES CONTROL CHARGE OR
DEFECTIVE BATTERY PACK
RED LIGHT "ON"
INDICATES FAST
CHARGING MODE
Fig. 3
BATTERY
PACK
BATTERY
CHARGER
■
The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
■
DO NOT
use or store charger in an area where tem-
perature is below 50
°
F or above 100
°
F.
IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERIES
When using your saw continuously, the batteries in your
battery pack become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting to
recharge.
NOTE:
This situation occurs when continuous use of your
saw causes the batteries to become hot. It does not occur
under normal circumstances. Refer to
"Charging Battery
Pack"
for normal recharging of batteries. If the charger does
not charge your battery pack under normal circumstances,
return
both
the battery pack and charger to your nearest
Authorized Service Center
for electrical check.
OPERATION