background image

ENGINE STARTING PROCEDURE

995000427

3-6-18 (REV:01)

Press and hold the on/stop 

switch to the off position 

( O )

.

To Stop:

For any questions about operating or maintaining your product, call the Ryobi Help Line!

Your Product has been fully tested prior to shipment to ensure your complete satisfaction.

Troubleshooting tips are also available in your operator’s manual.

Go to 

www.ryobitools.com

 and register your new tool on-line.

CALL

1-800-860-4050

www.ryobitools.com

50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with

1 gallon of fresh gasoline in separate gas 

container.  SHAKE.  Pour into fuel tank.

       WARNING: 

This Engine Starting Procedure is not a substitute for reading 

the operator’s manual. To reduce the risk of injury, user must read and 

understand operator’s manual before using this product.

Pull starter grip and rope sharply until engine attemps to run. Do

not pull starter grip more than 5 times.

Pull the starter grip and rope until the engine runs. 

Do not pull starter grip more than 6 times.

NOTE:  

If engine does not not start, return to the START 

position and repeat the steps that follow.

x10

Slowly press the primer bulb 10 times.

NOTE: 

After the 10th press, fuel should be visible in the primer bulb. If it is not, 

continue to press the primer until you see fuel in the bulb.

Set the choke lever to CHOKE position.

Set the choke lever to the RUN position.

Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times.

Set the choke lever to the RUN position.

Отзывы: