Ryobi RY124050, Руководство оператора

Страница: 10 / 42

8 — English
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts
INSTALLING/REMOVING THE AUXILIARY
HANDLE ASSEMBLY
See Figure 2.
The auxiliary handle assembly can be installed on either
side of the tool.
To install the auxiliary handle assembly:

Remove the battery pack.

Turn the handle grip counterclockwise to loosen it and
open the collar wide enough to fit over the front of the
power cleaner.

Place the collar as shown.

Turn the handle grip clockwise to tighten. Make sure the
handle assembly is secure before beginning operation.
CONNECTING THE SPRAY WAND TO THE
POWER CLEANER
See Figure 3.


Align the arrows and insert the end of the spray wand into
the power cleaner and push it until it clicks into place.

Pull on the spray wand to be certain it is properly secured.

To remove, press the button on the power cleaner and
pull to remove the spray wand.
CONNECTING THE 3-IN-1 NOZZLE TO THE
SPRAY WAND
See Figure 4.


Align the arrows and insert the end of the 3-in-1 nozzle
into the spray wand and push it until it clicks into place.

Pull on the 3-in-1 nozzle to be certain it is properly secured.

To remove, press the button on the wand and pull to
remove the 3-in-1 nozzle.
CONNECTING THE SIPHON HOSE TO THE
POWER CLEANER
See Figure 5.
The siphon hose can be submerged directly into any fresh
water source like a lake, pool, or a 5 gal. bucket for maxi-
mum portability

Completely uncoil and straighten the siphon hose to
prevent kinks.

Align the quick connect collar on the siphon hose to the
water inlet on the power cleaner.

Push the collar onto the water inlet until it clicks securely
into place.

Pull on the hose to be certain it is properly secured.
CONNECTING A GARDEN HOSE TO THE
POWER CLEANER
See Figure 6.
The power cleaner can be attached to a garden hose by
using one of the following methods.
NOTICE:
Always observe all local regulations when connecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drinking
water supply. Direct connection through a receiver tank
or backflow preventer is usually permitted.
NEVER use hot water. Before connecting a garden hose to
the power cleaner:


Run water through the hose for 30 seconds to clean any
debris from the hose.
To connect a garden hose to the siphon hose:


Completely uncoil the garden hose or remove completely
from reel to prevent kinks.
NOTE:
There must be a minimum of 10 feet of unrestricted
hose between the power cleaner intake and the hose
faucet or shut off valve (such as a “Y” shut off connector).


Unscrew and remove the filter from the end of the siphon
hose. Store filter for later use.


With the hose faucet turned completely off, attach the
end of the garden hose to the siphon hose water intake.
Tighten by hand.
To connect a garden hose to the power cleaner:


Completely uncoil the garden hose or remove completely
from reel to prevent kinks.