10
WARNING
To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch the plug with wet
hands.
SPECIFICATIONS
Product Specifications
Voltage
220 - 240VAC, 50Hz
Power
500 W
No-load speed
2900 min
-1
± 10%
Weight
15.5 kg (N.W.)
Measured sound pressure
level
L
pA
=
61.0 dB(A)
Uncertainty K
3 dB(A)
Measured sound power level
L
WA
=
77.0 dB(A)
Uncertainty K
3 dB(A)
Features
Table size
381 mm x 502 mm
Table height from cabinet to
table
181 mm
Material Specifications
Table material
Plastic / stainless steel
Stand material
Steel tubing
Cutting Tools/Capacity
Blade diameter
178 mm
Blade type
Diamond
Blade arbor
22.2 mm
Bevel range
0º, 22.5º, 45º
Maximum depth of cut at 0º
33 mm
Maximum depth of cut at 45º
22 mm
KNOW YOUR TILE SAW
178 mm tile cutting blade
– A 178 mm tile cutting blade is included with your
saw.
Bevel table
– Beveled 22.5° and 45° cuts can be made using the
bevel table.
Handles
– Saw has convenient handles located on left and
right side for lifting and carrying.
motor. Wire that is heavy enough for a short distance will
be too light for a greater distance. A line that can support
one power tool may not be able to support two or three
tools.
GROUNDING INSTRUCTIONS
This product must be grounded. In the event of a
malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the risk
of electric shock. This tool is equipped with an electric
cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into a
matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
WARNING
Improper installation of the grounding plug could
result in a risk of electric shock. The wire with green-
coloured insulation (with or without yellow stripes) is the
grounding wire.
Check with a qualified electrician or service personnel if
the grounding instructions are not completely understood
or if in doubt as to whether the product is properly
grounded.
Repair or replace a damaged or worn cord immediately.
Only connect the product to an outlet having the same
configuration as the plug. Do not use an adapter with this
product.
If the saw is used with an extension cord, ensure the
connection of the power cord of the tool and the extension
cord are not on the ground. Auxiliary devices should
always be plugged into the wall outlet and not at the
connection of an extension cord and the power tools’
power cord.
POSITION OF THE TILE SAW
See Figure 1.
To avoid the possibility of the tool plug or outlet getting
wet, position tile saw to one side of a wall-mounted outlet
to prevent water from dripping onto the outlet or plug.
The operator should arrange a “drip loop” in the cord
connecting the saw to the outlet. The “drip loop” is that part
of the cord below the level of the outlet, or the connector if
an extension cord is used, to prevent water traveling along
the cord and coming in contact with the outlet.
If the plug or outlet does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power
to the tool then unplug and examine for the presence of
water in the outlet.
