Ryobi RTS12T, Руководство оператора

Страница: 36 / 140

36 - English
MAKING A MITER CUT
See Figure 47.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.

Remove the rip fence.
 Set the blade to the correct depth for the workpiece.

Set the miter gauge to the desired angle and tighten the
lock knob.

Make sure the workpiece is clear of the blade before
turning on the saw.

Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.

Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.

When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
MAKING A BEVEL CROSS CUT
See Figures 48 - 49.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid possible serious injury.

Remove the rip fence.
 Unlock the bevel locking lever.

Adjust the bevel angle to the desired setting.

Lock the bevel locking lever.

Set the blade to the correct depth for the workpiece.

Set the miter gauge to 0° and tighten the lock knob.

Make sure the workpiece is clear of the blade before
turning on the saw.

Turn the saw on.

Let the blade build up to full speed before moving the
workpiece into the blade.

Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE:
The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.

When the cut is made, turn the saw off. Wait for the blade
to come to a complete stop before removing the workpiece.
OPERATION
VIEWED FROM THE FRONT, BELOW THE TABLE SAW
TO
LOOSEN
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
BEVEL
LOCKING LEVER
TO TIGHTEN
MITER CUT
MITER GAUGE
ANGLED
BEVEL CROSS CUT
BLADE
ANGLED
BLADE
STRAIGHT
Fig. 47
Fig. 48
MITER GAUGE
STRAIGHT
Fig. 49