5
center to avoid risk. Contact authorized service center.
WARNING
Do not at anytime let brake fl uids, fuel, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Use clean cloths to remove dirt, carbon dust, etc. When
electric tools are used on fi breglass boats, sports cars,
wallboard, spackling compounds or plaster, it has been
found that they are subject to accelerated wear and
possible premature failure, as the fi berglass chips and
grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently it is not recommended
that this tool be used for extended work on any fi berglass
material, wallboard, spackling compounds or plaster.
During any use on these materials, it is extremely
important that the tool is cleaned frequently by blowing
with an air jet.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
LUBRICATION
All of the bearings in this tool are lubricated with a
suffi cient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety Alert
V
Volts
Hz
Hertz
Alternating Current
W
Watts
n
o
No-load speed
min
-
1
Revolutions or reciprocations per minute
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Class II tool, double insulation
Wear ear protection
Wear eye protection
Read the instructions carefully before starting
the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
