Ryobi RMS-350, Руководство по эксплуатации для владельца

Страница: 6 / 8

5
DESCRIPITION
SPECIFICATIONS
Voltage ................................................
Power input ....................................................
No load speed .........................................
Stroke length ..................................................
Cutting capacity ..................................
Net weight ........................................................
230V ~ 50Hz
350W
2,350min
-1
18mm
wood: 60mm
metal: 6mm
1.5kg
1. Blade
2. Blade clamp release lever
3. Pivot blade shoe
4. On/ Off switch
5. Lock on button
6. Cord restraint
ACCESSORIES:
a. Wood blade x 1pc
b. Metal blade x 1pc
c. Pruner blade x 1pc
ATTACHING AND REMOVING SAW BLADE (Fig. 1)
PIVOTING BLADE FOOT (Fig. 2)
Rotate the blade clamp release lever (2), insert the blade
shank into the blade clamp through the blade guard until it
stops. Ensure the small hole in the blade is on the pin in the
clamp then release the lever. Pull up on blade to make sure
that it is locked in.
To remove a blade, carry out these instructions in reverse
order.
The pivoting blade foot (3) must be held firmly against the
material being cut to reduce saw vibration, blade jumping
and blade breakage.
OPERATION
MAINTENANCE
STORAGE
CAUTION! The tool should run at full speed before the
blade enters the workpiece.
ALWAYS KEEP TOOL AND CORD CLEAN.
CAUTION! Disconnect the plug before cleaning.
DO NOT MAKE ANY ADJUSTMENTS WHILE THE MOTOR
IS IN MOTION.
After use, check the tool to make sure that it is in top
condition.
It is recommended that you take this tool to a RYOBI
Authorized Service Center for a thorough cleaning and
lubrication at least once a year.
Store the tool indoors in a dry and locked-up place, out of
reach of children.
To ensure safety and reliability, all repairs should be
performed by an AUTHORIZED SERVICE CENTER or
other QUALIFIED SERVICE ORGANIZATION.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING! While working, always hold the tool at the
grey colored grip area(s).
ON/OFF SWITCH (Fig. 3)
• Switch on tool by first pressing Lock on button (4) and then
pulling On/ Off switch (6).
• Switch off tool by releasing On/ Off switch (6).
• Connect plug to power source.
• Ensure power cord is located to the rear, away from the
saw blade and so positioned that it will not be caught on
branches or the like during cutting.
• Switch on the tool.
• Always engage the moving saw blade into the workpiece in
a downward direction.
• Keep footplate firmly against the workpiece to minimize
counter-force and vibration.
• Do not apply too much pressure on the tool; let the tool do
the work for you.
• Keep ventilation slots uncovered.
WARNING! Ensure that the saw blade extends beyond
the work throughout the stroke.
WARNING! There is a risk of accidents when sawing
wood or branches under tension, be careful!
• Support workpiece/ logs so that the face sides at the cut
do not close in against each other, which would result in the
blade being jammed or pinched.
• Position and set short logs safely prior to sawing.
WARNING! Blade teeth are very sharp. For best cutting
results ensure you use a saw blade suited to the material
and cut quality you need.
It is possible to make cuts extremely close to floors, walls
and other difficult areas. Insert the blade shank into the
blade clamp with the blade teeth facing up (opposite to
normal working position). This will make cuts closer to the
work surface.