
11
TROUBLESHOOTING
If these solutions do not solve the problem, contact your authorised service dealer.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Engine will not start.
No fuel.
Push primer bulb until bulb is full of fuel.
If bulb does not fill, primary fuel delivery
system is blocked. Contact a servicing
dealer. If primer bulb fills, engine may be
flooded, proceed to next item.
Engine is flooded.
Pull starter with choke lever at “Run”
position and wide open throttle. If engine
does not start, move choke lever to
“Full” position and repeat normal starting
procedure. If engine still fails to start,
repeat procedure with a new spark plug.
No spark.
Check spark. Remove spark plug.
Reattach the spark plug cap and lay
spark plug on metal cylinder. Pull the
starter rope and watch for spark at spark
plug tip. If there is no spark, repeat test
with a new spark plug.
Starter rope pulls harder now than when
new.
Contact a servicing dealer.
Engine starts but will not accelerate.
Engine requires approximately three
minutes to warm up.
Allow engine to completely warm up. If
engine does not accelerate after three
minutes, contact a servicing dealer.
Engine starts but will only run at high
speed at half choke.
Carburetor requires adjustment.
Contact a servicing dealer.
Engine does not reach full speed and
emits excessive smoke.
Check lubricant fuel mixture.
Use fresh fuel and the correct 2-stroke
lubricant mix.
Air filter is dirty.
Clean air filter. Refer to Cleaning the Air
Filter earlier in this manual.
Spark arrestor screen is dirty.
Contact a servicing dealer.
Engine starts, runs, and accelerates but
will not idle.
Idle speed screw on carburetor requires
adjustment
Contact a servicing dealer.
NOTE:
If your unit exhibits specific performance problem(s) where the Troubleshooting section recommends a clockwise screw
adjustment on the carburetor and no adjustments have been made since original purchase, the unit should be taken to an
authorized service centre for repair. In most cases, the needed adjustment is a simple task for the trained service representative.