Safety
4
WARNING
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping.
■
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■
If any parts are damaged or missing, please call Ryobi
Customer Service for assistance:
AUS: 1300 361 505
NZ: 0800 279 624
PACKING LIST
Edger Attachment
Holding Pin
Wrench
Operator’s Manual
Battery (for RED3626 only)
Charger (for RED3626 only)
WARNING
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
CONNECTING THE POWER HEAD TO THE EDGER
ATTACHMENT
See Figure 2.
WARNING
Never install, remove, or adjust any attachment while
power head is running or with the battery pack installed.
Failure to stop the motor or remove the battery pack can
result in serious personal injury.
The attachment connects to the power head by means of
a coupler device.
■
Remove the battery pack if installed.
■
Align the arrows on the edger attachment and the
power head. Then, insert the plug on the attachment
into the opening on the coupler. Make sure the plug is
fully seated.
■
Slide the threaded coupler on the power head onto the
threaded base on the attachment and turn the coupler
clockwise. Tighten securely.
NOTE:
Once assembled correctly, the edger attachment
and power head should not separate when pulled. Repeat
above steps if pieces can be separated.
WARNING
Failure to secure the edger attachment and power head
as instructed above could result in serious personal
injury.
REMOVING THE EDGER ATTACHMENT FROM THE
POWER HEAD
■
Remove the battery pack.
■
Turn the coupler counterclockwise to unlock. Then
remove the edger shaft from the power head.
DESCRIPTION
Figure 1
1. Edger attachment shaft
2. Blade guard
3. Gear head
4. Blade
5. Guide wheel
6. Depth adjusting lever
7. Coupler
8. Front handle
9. Lock-out
10. Switch trigger
11. 36 V battery
Figure 2
7. Coupler
12. Base
13. Arrow
Figure 3
11. 36 V battery
14. Latch
Figure 4
15. Knob