Ryobi RCV36, Оригинальное руководство пользователя

Страница: 9 / 24

8
4
3
2
1
D
C
1
2
3
4
A
B
1 5 6
1
2
1
2
3
4
1/4-20UNC-2B
3
2
4
1
1/4-20UNC-2B
2
1
9 11 8 10 12
GETTING STARTED GETTING STARTED GETTING STARTED GETTING STARTED
A
B
C
D
A
B
C
D
1
2
1
2
3
3 2 4
Push the lock button, and slide out the hanger cap from the
cultivator shaft.
Install the metal cover. Install the bolts and nuts onto the metal cover, and tighten
the bolts.
1
2
7
Wear full eye and ear protection, substantial footwear, and
long trousers at all times while operating the product. Do
not operate the product when barefoot or wearing open
sandals.
Place tine B on the tine shaft to the right of the gear box.
The stamped side of the tine should face away from the
gear box. Place a felt washer on the tine shaft. Place the
outer tine labeled A on the right side of the tine shaft. The
stamped side should face inward, toward tine B. To secure
the tines to the tine shaft, insert the hitch pin into the holes
at the end of the tine shaft.
Place tine C on the tine shaft to the left of the gear box. The
stamped side of the tine should face away from the gear
box. Place a felt washer on the tine shaft. Place the outer
tine labeled D on the left side of the tine shaft. The stamped
side should face in toward tine C. To secure the tines to the
tine shaft, insert the hitch pin into the holes located on the
side of the tine shaft.
Insert cultivator shaft into the power head shaft until the lock
button snaps and locks the cultivator shaft in place. Tighten the
knob to secure the shafts.
WARNING:
The product will not operate properly if the tines are incorrectly installed.
Remove the nut, flat washer, and bolt from the top clamp. Install the top clamp on the power head shaft. Insert the handlebar
into the top clamp.
Hold the product by the designated handles and operate the
product as shown. The product must be adequately controlled by
using two-handed operation at all times.
Insert the battery pack into the product until it snaps in place. Install the bolt, flat washer, and nut. Tighten the nut to secure
the handlebar.
Press and hold the trigger lock out, and squeeze the switch trigger
to turn on the product.