5
4
1. Loosen the depth adjustment screw using the depth locking
lever.
2. Hold the base plate flat against the body of the work piece
and lift the body of the saw until the blade is at the right
depth.
3. Tighten the depth locking lever.
1. Loosen the angle locking knob.
2. Adjust the shoe to the desired angle between 0º and 45º.
3. Retighten the angle locking knob.
1. Mark a cutting line on the workpiece.
2. Rest the front part of the shoe flat on the workpiece surface
with the blade not making any contact with the workpiece.
3. Switch on the tool and allow it to reach its full speed.
4. Align the saw blade with the cutting line on the workpiece,
gently push the saw forward. Never force the saw but
maintain a light and continuous pressure when completing
the cut. Switch off the tool only after the tool is completely
away from the workpiece. If the cutting is interrupted,
resume the cut by allowing the blade to reach full speed and
then reentering the cut slowly.
5. When cutting across the grain, the fibers of the wood will
have a tendency to lift and tear. Move the saw slowly to
minimize this effect.
MAINTENANCE
ENVIRONMENTAL PROTECTION
WARNING!
Preventive maintenance performed by unauthorized personnel
may result in misplacing of internal wires and components which
could cause serious hazard.
WARNING!
If any of the following events occur during normal operation, the
power supply should be shut off at once and tool thoroughly
inspected by a qualified person and repaired if necessary:
CAUTION!
Always be sure that the tool is switched off and unplugged
before attempting to perform inspection or maintenance.
Regularly clean the tool’s air vents with compressed dry air. do
not attempt to clean by inserting pointed objects through
openings.
CAUTION!
Certain cleaning agents and solvents may damage plastic parts.
Some of these are: gasoline, carbon tetrachloride, chlorinated
cleaning solvents, ammonia and household detergents that
contain ammonia.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
Recycle raw materials instead of disposing of as waste.
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
NOTE
For best cutting results, always ensure that saw blade protrudes
no more than 3mm below the bottom surface of the workpiece.
NOTE
There are two notches on the front edge of the shoe as an aid for
alignment. When making a 45° bevel cut, align the left notch
marked with 45° with the cutting line on the workpiece. For a
straight 90° cut, align the right notch marked with 0° with the
cutting line on the workpiece. For precise cutting, always make a
trial cut before carrying out operation.
SPECIFICATIONS
Voltage:
Power rating:
No load speed:
Blade diameter:
Blade arbor
：
Blade teeth
：
Max. cutting depth
at 90°
：
at 45°:
Nett weight:
230-240V~50Hz
1350W
5500min
-1
Ø185mm (
7 1/4")
Ø16mm
24T
62mm
46mm
3.6kg
DEPTH ADJUSTMENT (Fig. 6)
ANGLE ADJUSTMENT (Fig. 7)
GENERAL CUT (Fig. 8)
NOTE
■
The rotating parts get stuck or speed drops abnormally low.
■
The tool shakes abnormally accompanied by some unusual
noise.
■
The motor housing gets abnormal hot.
■
Heavy sparks occur around the motor area.
If the cable or plug is damaged, have the cord set
replaced by an authorised service agent or
appropriately qualified person.