Ryobi RBV254O, Оригинальное руководство пользователя, Страница: 9 / 43

9
FUELLING AND REFUELLING
MIXING THE FUEL
The product is powered by a 2-stroke engine
and requires premixing petrol and 2-stroke oil.
The mixture should be at a 50:1 ratio.
NOTE: We recommend you use RYOBI
synthetic 2-stroke lubricant. Only use a quality
synthetic 2-stroke lubricant in the product to
ensure top performance and engine longevity.
NOTE: If using similar containers for different
fuels, label the container with its contents and
the date it was added.
TO MIX THE FUEL:
■ Pre-mix unleaded petrol and 2-stroke
engine lubricant in a clean container
approved for petrol.
■ The engine of the product is certified to
operate on unleaded petrol intended for
automotive use with an octane rating of 91
or higher.
■ Do not use any type of pre-mixed petrol/
lubricant from fuel service stations; this
includes the pre-mixed petrol/lubricant
intended for use in mopeds, motorcycles,
etc.
■ Avoid using ethanol fuels or fuels containing
ethanol. The use of ethanol fuels may result
in damage to the engine of the product.
■ Use only synthetic 2-stroke lubricant. Do
not use automotive lubricant or 2-stroke
outboard lubricant.
■ Mix 2% synthetic 2-stroke lubricant into the
petrol. This is a 50:1 ratio.
■ Mix the fuel thoroughly and also each time
before fuelling.
■ Mix in small quantities. Do not mix quantities
larger than usable in a 30-day period. A
synthetic 2-stroke lubricant containing a
fuel stabiliser is recommended.
1 L + 20 mL =
2 L + 40 mL =
3 L + 60 mL = 50:1 (2%)
4 L + 80 mL =
5 L + 100 mL =
FILLING THE TANK
WARNING
Petrol is extremely flammable and explosive.
A fire or explosion from petrol will burn you
and others. Always shut off engine before
fuelling. Never add fuel to a machine with
a running or hot engine. Move at least 9 m
from refuelling site before starting engine.
Do not smoke and stay away from open
flames and sparks. Failure to safely handle
fuel could result in serious personal injury.
1. Clean the surface around the fuel cap to
prevent contamination.
2. Loosen the fuel cap slowly.
3. Pour the fuel mixture carefully into the tank.
4. Clean and inspect the fuel cap gasket
before replacing the fuel cap.
5. Replace the fuel cap and tighten it. Do not
cross thread the fuel cap.
6. Wipe spilled fuel from the product.
7. Move at least 9 m away from refuelling
area before starting the product.
NOTE: It is normal for smoke to be emitted
from a new engine during first use.
WARNING
Check for fuel leaks. A leaking fuel cap
is a fire hazard and must be replaced
immediately. If you find any leaks, correct
the problem before using the product.
Failure to do so could result in a fire that
could cause serious personal injury.
USING THE BLOWER
See page 29.
■ To keep from scattering debris, blow
around the outer edges of a debris pile.
Never blow directly into the centre of a pile.
■ Operate power equipment at reasonable
hours only; not early in the morning or late
at night when people might be disturbed.
Comply with the times listed in local
ordinances.
■ To reduce sound levels, limit the number of
pieces of equipment used at any one time
and operate blower at the lowest possible