Ryobi RBL26G, Оригинальное руководство пользователя, Страница: 12 / 32

12
TROUBLESHOOTING
Problem Possible cause Solution
Engine fails to start.
No fuel in the tank. Fill the tank.
The spark plug shorted or fouled. Replace the spark plug.
The spark plug is broken (cracked
porcelain or electrodes broken).
Replace the spark plug.
The spark plug wire is shorted, broken,
or disconnected from spark plug.
Contact an authorised service centre.
Ignition is inoperative. Contact an authorised service centre.
Engine flooded Remove spark plug, turn blower to aim
spark plug hole at the ground. Adjust
the choke lever to “RUN” position and
pull starter cord 10-15 times. This will
clear excess fuel from the engine.
Remove any fuel which is splashed
on the product. Clean and reinstall
spark plug. Clean up any spilled fuel
and move at least 9 m away before
restarting. Pull starter cord 3 times with
choke lever at “RUN” position. If engine
does not start, rotate choke lever to
“COLD START” position and repeat
normal starting procedure. If engine still
fails to start, repeat procedure with a
new spark plug.
Engine is hard to start.
Water in petrol or stale fuel mixture. Drain entire fuel system and refill with
fresh fuel.
Too much lubricant in fuel mixture. Drain and refill with correct mixture.
Engine is under or over choked. Adjust choke as necessary.
Weak spark at spark plug Contact an authorised service centre.
Engine lacks power. Dirty air filter Clean or replace the air filter.
Engine overheats.
Insufficient lubricant in fuel mixture. Mix fuel as describe in the operation
section.