Ryobi RBC254SSEON, Оригинальное руководство пользователя

Страница: 26 / 32

TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT AN AUTHORISED SERVICE CENTRE.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start No spark The spark plug may be damaged. Remove it and check for dirt
and cracks. Replace with a new spark plug.
No fuel Push the primer bulb until the bulb is full of fuel. If bulb does
not fill, the primary fuel delivery system is blocked. Contact an
authorised service centre. If the primer bulb fills, the engine may
be flooded. Proceed to the next item.
Engine is flooded Remove the spark plug. Turn the product so the spark plug hole
is aimed at the ground. Rotate the choke dial to “ ” position
and then pull the starter cord 10 to 15 times. This will clear
the excess fuel from the engine. Remove any fuel splashed
on the product. Clean and reinstall the spark plug. Clean any
spilled fuel and move at least 9 m away before restarting. Pull
the starter three times with choke dial at “ ”. If the engine
does not start, rotate the choke dial to “ ” position and then
repeat the normal starting procedure. If the engine still fails to
start, repeat the procedure with a new spark plug.
Starter rope is harder to pull Contact an authorised service centre.
Old fuel Only use fresh fuel mixed with recommended oil. Fuel over 30
days old may prevent the product from starting.
Engine starts but will not accelerate Engine requires approximately
three minutes to warm up
Allow the engine to completely warm up. If engine does not
accelerate after three minutes, contact an authorised service
centre.
Engine starts but will only run at
high speed at half choke
Carburetor requires adjustment Contact an authorised service centre.
Engine does not reach full speed
and emits excessive smoke
Check the lubricant fuel mixture Use fresh fuel and the correct 2-stroke lubricant mix.
Air filter is dirty Clean air filter.
Spark arrestor screen is dirty Contact an authorised service centre.
Engine starts, runs, and accelerates
but will not idle
Idle speed screw on carburetor
requires adjustment
Contact an authorised service centre.
Lubricant drips from muffler Operating the product at part
throttle
Operate the product at full throttle.
Lubricant/fuel mixture is dirty Use fresh fuel and correct synthetic 2-stroke lubricant mix.
Air filter is dirty Clean the air filter