Ryobi RB-264S, Руководство по эксплуатации для владельца, Страница: 11 / 16

11
MAINTENANCE
4. Clean the electrodes (metal tip) to refresh the
surfaces.
5. Check the spark plug gap. It should be
between 0.7-0.8 mm.
6. Replace the spark plug and its cap.
STORAGE
1. Store the machine out of reach from children
and other unauthorized persons in a well
ventilated, dry and frost-free environment.
2. Empty the oil and fuel tank before long-time
storage.
3. Protect the machine against dust.
4. Change the oil if you want to use the machine
after more than 1 month of storage.
TROUBLESHOOTING
Problem Possible Cause Solution
No fuel in tank.
Spark plug shorted or fouled.
Spark plug is broken.
(cracked porcelain or
electrodes broken)
Ignition lead wire shorted,
broken, or disconnected from
spark plug.
Ignition inoperative.
Water in gasoline or stale
fuel.
Engine is under or over
choked.
Weak spark at spark plug.
Air filter clogged.
Too much oil in crankcase.
Fill tank.
Replace spark plug.
Replace spark plug.
Replace lead wire or attach to spark plug.
Contact a qualified service center.
Drain entire system and refill with fresh fuel.
Adjust choke as necessary.
Contact customer support.
Clean air filter. Refer to Cleaning the Air Filter
earlier in this manual.
Drain lubricant and refill with correct amount of
10W30 engine lubricant. See Adding/Checking
Engine Oil in the Operation section of this manual.
Engine fails to start.
Engine hard to start.
Engine lacks power.
Engine emits too much
smoke.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the
Maintenance section. It is recommended that you retain all receipts covering maintenance on your
equipment. Neglecting or failing to perform the required maintenance may increase emissions, decrease
fuel efficiency, degrade performance, cause irreversible engine damage and/or void your warranty.