![background image](http://html1.mh-extra.com/html/ryobi/ra-n-b/ra-n-b_operators-manual_1505913009.webp)
5
■
Only lubricants recommended by the manufacturer
should be used.
■
Drain the air tank daily. Water in the air line will
damage the product.
■
If the product cannot be used anymore, make sure to
dispose of it so as not to impose hazards on people
and the environment.
■
Clean the air inlet filter on the nibbler and compressor
weekly.
REpLAcINg thE BLADE
See figure 5-10.
■
Make sure to disconnect the product from air supply.
■
Loosen and remove the cutting set.
■
Loosen and remove cutter retaining screw.
■
Remove the cutter from the cutter retaining screw.
■
Insert a new cutter (not included) into the connecting
rod. Then insert the cutter retaining screw and tighten
it. (Tightening torque: 3-6 Nm)
■
Screw in the cutting set. Make sure that:
–
the hole on the cutting set faces the front as
shown, and
–
the cutting set is 35 mm protruding from the
nibber's head.
■
Using a wrench to hold the cutting set in place, tighten
the locking nut.
WARNINg
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
syMBOLs
Safety alert
CE conformity
Please read and understand all instructions
before operating the product, follow all
warnings and safety instructions.
Please read the instructions carefully before
starting the product.
Wear eye protection.
Wear ear protection.
Lubricate with air tool oil daily.