Ryobi OP400, Руководство оператора

Страница: 7 / 24

7 — English
OPERATION
MAINTENANCE
WARNING:
When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any
maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
STORAGE
Always remove the battery pack before storing the charger
or any time the charger is unplugged.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the red LED will begin
flashing and the green LED will be off. When the battery
pack warms to approximately 32°F (0°C), the charger will
automatically begin charging.
LED FUNCTION OF CHARGER
See Figure 3, page 9.
CHARGER LED WILL FUNCTION AS FOLLOWS
TO INDICATE STATUS OF CHARGER AND
BATTERY PACK:

Red LED on, Green LED off = Power to charger is on.

Red LED flashing, Green LED off = Battery is being tested.

Red LED flashing, Green LED flashing = Battery is
defective.

Red LED off, Green LED flashing = Battery is charging.

Red LED off, Green LED on = Battery is fully charged.