4
NOTE:
Servicing of a product with double insulation
requires extreme care and knowledge of the system and
should be performed only by a qualifi ed service technician.
For service, we suggest you return the product to your
nearest authorized service center for repair. Always use
original factory replacement parts when servicing.
ELECTRICAL CONNECTION
The product has a precision-built electric motor. It should
be connected to a power supply that is 230 volts, AC only
(normal household current), 50 Hz. Do not operate the
product on direct current (DC). A substantial voltage drop
will cause a loss of power and the motor will overheat. If
the product does not operate when plugged into an outlet,
double-check the power supply.
EXTENSION CORDS
When using a power tool at a considerable distance from
a power source, be sure to use an extension cord that has
the capacity to handle the current the product will draw. An
undersized cord will cause a drop in line voltage, resulting
in overheating and loss of power.
When working outdoors with a product, use an extension
cord that is designed for outside use.
WARNING
Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other
harm. Some examples of these chemicals are:
lead from lead-based paints
crystalline silica from bricks and cement and
other masonry products, and
arsenic and chromium from chemically-treated
lumber
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals, work in a well ventilated
area, and work with approved safety equipment, such
as dust masks that are specially designed to fi lter out
microscopic particles.
SPECIFICATIONS
Input
230 V - 240 V 50 Hz
Rated speed
10,000-35,000 (RPM) min
-1
Collet
3.2 mm max.
Weight
0.73 kg
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is suffi cient to infl ict serious injury.
WARNING
Always wear eye protection marked to comply with
ANSI Z87.1. Failure to do so could result in objects
being thrown into your eyes resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of the product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use the product for the purposes listed below:
Cutting
Sanding
Polishing and buffing
Engraving
Drilling
TURNING THE ROTARY TOOL ON/OFF
See Figure 2.
To turn the tool on: Push “ | ”.
To turn the tool off: Push “ O ”.
CAUTION
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging the spindle lock.
CHANGING COLLETS
See Figure 3.
Unplug the rotary tool.
Press and hold the spindle lock, and rotate the shaft
with the provided collet wrench until the spindle lock
engages the shaft, preventing further rotation.
With the spindle lock engaged, use the collet wrench
to loosen the collet nut, if necessary.
Remove the collet nut and old collet using collet
wrench, if necessary.
Insert the unslotted end of the collet in the hole at the
end of the tool shaft.
Replace the collet nut on the shaft.
