Pape 3
USING THE HEAT GUN
The heat gun is very easy to use. Before plugging the heat gun
in, always ensure that the switch is set to 0. (OFF) When you
are ready, adjust the switch (4) to setting 1 or 2. Always allow
the heat gun to warm up for at least 1minute to reach the
operating temperature. Always wear gloves and eye protection.
The heat gun has a built-in stand to keep it upright on a flat
horizontal surface. This leaves both hands free for softening
PVC pipes or other material. Always keep your hands away
from the nozzle.
If your heat gun model has a variable temperature control (3)
you can rotate this to adjust to different temperatures. If
your heat gun model has LED temperature indicator (6) (Fig.4)
then you can take a reference on the LED indicator to
know what is the approximate working temperature.
Ensure that the power supply corresponds to the rating
plate on the heat gun. The power supply should be 240V
50HzAC (normalmains).Voltage deviation greater than
10% may cause loss of power and possible overheat.
For greater safety, the heat gun is double insulated. This
means that there are two separate insulation systems
between the user and the live elements of the heat gun.
Warning: Although the heat gun is double insulated, normal
safety precautions should be taken when using the heat
gun to avoid injury that may be caused by a failure of the
electrial installation inside the equipment.
This tool is not designed to be earthed.The heat gun power
cable is, therefore fitted with a two pin plug for use in normal
240V power sockets.
EHG2002LED
2000W
240V
50Hz
250 to 500 l/min 250 and 500 l/min
Yes
Yes
EHG2002
2000W
240V
50Hz
50
o
C-650
o
C 60
o
C and 600
o
C
2 Temperature
No
Model No.:
Rating:
Voltage:
Frequency:
Temperature:
Air flow:
Variable temperature
adjust:
LED temperature
indicator:
STRIPPING PAINT AND VARNISH
Never use the heat gun in combination with solvents.
After use, remove any paint or varnish residue on the
nozzle and scrappers. This could catch fire.
Always work in a well ventilated area. Flakes and residues
of lead-based paints are highly toxic.
DESCRIPTION
1. Accepts accessory nozzles
2. Guard sleeve
3. Variable temperature control (For EHG2002LED only)
4. Switch
5. Hanger & support stand
6. LED temperature indicator (For EHG2002LED only)
RULES FOR SAFE OPERATION
POWER SUPPLY
SPECIFICATION
