Ryobi EBS8076F, Руководство по эксплуатации для владельца

Страница: 7 / 8

4
ADJUSTABLE FRONT HANDLE (FIG. 5)
FRONT HANDLE RELEASE BUTTON
Press the front handle release button (4) to allow
the front handle to be adjusted to the desired working
position.
FRONT HANDLE ADJUSTMENTS
While depressing the front handle release button move
the handle upwards or downwards to the desired angle
of either -5, 0, 5 and 30 degrees. Release the front
handle release button to allow the handle to lock in to the
selected.
OPERATING (FIG. 6)
Never cover air vents since they must always be open for
proper motor cooling.
Make sure that the work piece is free of nails and other
foreign objects that could tear the abrasive belt.
Hold the tool firmly with both hands. Turn the switch on
and permit the rotation of the abrasive belt to reach full
speed. Then gently place the tool on the work piece
surface. Move the tool back and forth. Never exert
excessive pressure on the tool. The weight of the tool
applies adequate pressure. Excessive pressure will retard
the abrasive action, leave an uneven finish and cause
extra wear to both the tool and the abrasive belt. Always
lift the tool off the work piece before turning the switch off.
LIVETOOL INDICATOR TM
This tool features a Livetool Indicator
TM
(3) which
illuminates as soon as the tool is connected to the power
supply. This warns the user that the tools is connected to
live power and will operate when the switch is pressed.
AUTO BELT TRACKING SYSTEM
The machine is designed with auto-belt tracking system.
Turn the tool upside down and hold it firmly with one
hand, then start the tool and observe the tracking of the
sanding belt.
The edge of the sanding belt will automatically be even
with the outer edges of wear plate.
The system has been preset at the factory but may
required adjustment when belt are changed or an older
belt stretches. If the edge of the belt deviates more than
3.75mm (/8 inch) from the edge of the wear plate,
adjust the belt by turning the auto-track adjusting screw
until the belt is even with the edge of wear plate.
CLAMP
The clamp is designed to stabilize the tool when using it in
the bench configuration.
MOUNT & ADJUSTING THE SANDING FRAME
Put the sanding frame on the belt sander and attach the
four slot into slot holder (5).
By turning the adjustment bolt clockwise, the sanding
frame will rise and can be taken out. If turning
counterclockwise, it will down and the depth will be
added.
MAINTENANCE
After use, check the tool to make sure that it is in top
condition.
It is recommended that you take this tool to a Ryobi
Authorized Service Centre for a through cleaning and
lubrication at least once a year.
Do not make any adjustment while the motor is in motion.
Always disconnect the power cord from the receptacle
before changing removable or expendable parts (blade,
bit, sanding paper etc.), Lubricating or working on the
unit.
If the supply cord is damaged, it shall be replaced by
the manufacturer or its service centre or similar qualified
person in order to avoid a hazard.
WARNING!
To ensure safety and reliability, all repair should
be performed by an AUTHORIZED SERVICE
CENTRE or other QUALIFIED SERVICE
ORGANIZATION.
SAVE THESE INSTRUCTION FOR FURTURE
REFERENCE.
ENVIRONMENTAL PROTECTION
Do not dispose of in general household waste.
Instead, dispose in an environmentally friendly
way. Contact your local recycling centre or
council for advise. Ryobi takes the care of the
environment very seriously.