OPERATING SPEEDS
& ACCESSORIES (Cont.)
The speed of the Hobby Tool is controlled by
adjusting the variable speed dial (Fig 7). The refer-
ence speed range is as the chart below.
Variable Speed
Speed Range
Dial Setting
(Reference Value)
1
7500 - 8000 r.p.m
2
8000 - 12000 r.p.m
3
12000 - 15000 r.p.m
4
15000 - 18000 r.p.m
5
18000 - 21000 r.p.m
6
21000 - 26500 r.p.m
■
GENERAL
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, etc.
Do not use electric tools on fibrglass and other
abrasive materials as the abrasive material tends to
cause accelerated wear and possible premature
failure of bearings, brushes, commutator and other
parts. Consequently, this tool should not be used
for work on fibreglass or other abrasive materials.
■
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life
of the unit under normal operating conditions.
Therefore, no further lubrication is required.
WARNING:
Do not at ant time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc
come into contact with plastic parts. They contain
chemicals that can damage, weaken or even
destroy plastic.
■
OPTIONAL ACCESSORY
A flexible drive shaft is available as an optional
accessory. It is ideal for hard to reach and confined
areas. Part No. 6200892004.
■
ATTACHING THE OPTIONAL FLEXIBLE SHAFT
TO HOBBY TOOL
1. To attach the flexible shaft to the Hobby Tool
remove the housing cap from the tool as shown in
figure 8. Then press the shaft lock button and rotate
the collet nut by hand until the shaft lock engages.
Unscrew collet nut and remove the collet.
2. Insert driver cable into collet (Fig.9) and secure
by tightening collet (fig.10). Slide driver cap over
collet and screw on to motor housing.
4. Insert the collet which is suitable for the shank
size you need and the collet nut to another end
of the flexible shaft. To change bits use the
wrench and bit.
5. Do not use the flexible shaft over 30000 rpm.
■
INSTALLING CUT-OFF WHEEL (A)
1. Loosen the screw in a anti-clockwise direction.
2. Put the cutting wheel on mandrel.
3. Tighten the screw in a clockwise direction with
wrench.
■
INSTALLING SANDER ROLLER (B)
1. Loosen the nut of sanding band.
2. Put the sanding roller on.
3. Tighten the nut in a clockwise direction.
■
INSTALLING POLISH WHEEL (C)
Screw the mandrel into the polish wheel.
Variable
Speed Switch
(1 - 6)
Fig 7
Fig 8
Fig 9
Fig 10
A
B
C
Screw
Cap
Collet
Driver Cap
Fig 11
