3
OPERATION
LED FUNCTION OF CHARGER
See Figure 9.
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
Red LED on = Fast charging mode.
Green LED on = Fully charged battery pack.
No LED on = Defective charge or battery pack.
FEATURES
Figure 1
A. Keyless chuck
B. Switch trigger
C
.
Direction of rotation selector (Forward/Reverse)
D. Screwdriver bits
E . Battery pack
F. Battery LCD indicator
Figure 2
A. Battery pack
B. Latches
C. Depress latches to release battery pack
Note:
Batteries will not reach full charge the first time
they are charged. Allow several cycles for them to
fully charge.
TO CHARGE
Charge battery pack only with the charger provided.
Make sure power supply is normal house voltage,
240 volts, 50 Hz, AC only.
Connect charger to power supply.
Place battery pack in charger. Align raised rib on
battery pack with groove in charger.
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
When your battery pack becomes fully charged, the
red light will turn off and the green light will turn on.
After normal usage, 1 hour of charge time is required
to be fully charged. A minimum charge time of 1 to
1-1/2 hours is required to recharge a completely
discharged tool.
DO NOT place charger in an area of extreme heat or
cold. It will work best at temperatures above 10
o
C
and below 38
o
C.
IMPORTANT INFORMATION FOR RECHARGING HOT
BATTERIES
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
CHARGING YOUR BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
Figure 7
A. Unlock (release)
B. Chuck
C. Drill bit
D. Chuck jaws
E. Lock (tighten)
Figure 8
A. High Speed
B. Low Speed
Figure 9
A. Battery Charger
B. Green Light
C. Red Light
D. Yellow and Green Light
Figure 3 (For CMI1442D/1802D)
A. Auxilary Handle
B. To Tighten
C. To Loosen
Figure 4 (For CMI1442D/1802D)
A. Drill bit
B. Depth Gauge Rod
C. Drilling Depth
Figure 5
A. To Decrease torque
B. To Increase torque
C. Torque adjusting Ring
D. Drill mode
E. Impact mode (For CMI1442D/1802D)
Figure 6
A. Forward / Reverse selector
B. Reverse
C. Forward
D. Switch
Green and Yellow LED on = Control Charge or Defective
Battery Pack.
Note: Normally the red light on the charger will come
on, this indicates charge mode. If the green and yellow
lights come on, remove the battery pack, wait 1 minute
and reinsert battery pack in charger. If the green and
yellow lights continue to remain on an additional 15
minutes, the battery pack is damaged and will not
accept charge. A maximum charge time of 1-1 1/2
hours is required to recharge a completely discharged
battery.
Figure
10
Battery level indicator
