WARNING
Improper chain sharpening increases the potential
of kickback.
Failure to replace or repair damaged chain can cause
serious injury.
The saw chain is very sharp, always wear protective
gloves when performing maintenance to the chain.
STORING THE PRUNER ATTACHMENT
Store the pruner attachment in a well ventilated place that is
inaccessible to children. Keep away from corrosive agents
such as garden chemicals and de-icing salts.
To remove the pruner attachment from the power head for
storage:
1. Loosen the knob on the coupler device.
2. Push the button in, then twist the shafts to remove and
separate the power head from the attachment.
For storing information:
Please refer to the Operator’s
Manual of your power head.
ATTACHING THE STORAGE HANGER
See Figure 27.
There are two ways to hang your attachment for storage.
■
To use the hanger cap (44), push in the button (12) and
place the hanger cap over end of the pruner attachment’s
shaft (5). Slightly rotate the cap from side to side until the
button locks into place.
■
The hanger hole (33) in the pruner attachment shaft can
be used for hanging purposes as well.
10
English
MAINTENANCE
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE
CAUSE
SOLUTION
Bar and chain running hot
1. Check chain tension for
1. Tension chain. Refer to “Chain Tension”earlier
and smoking.
overtight condition.
in this manual.
2. Chain oil tank empty.
2. Check oil tank.
Motor runs, but chain
1. Chain tension too tight.
1. Retension chain, Refer to “Chain Tension”
is not rotating.
earlier in this manual.
2. Check guide bar and chain
2. Refer to “Replacing the Bar and Chain”
assembly.
earlier in this manual.
3. Check guide bar and chain
3. Inspect guide bar and chain for damage.
for damage.
