Ryobi AJP-1600, Руководство по эксплуатации для владельца

Страница: 4 / 8

3
Safety devices
Safety lock on spray handle
The spray handle features safety lock. When the lock is activated, the spray handle cannot be operated.
Motor pump protection
The motor is equipped with a motor circuit breaker switch. When the motor starts to run hot, it is cut out by this switch. Switch
off the machine. Wait 5 ~ 10 minutes before using the device again. Try to determine the cause of the fault. If the problem re -
peats itself, please contact RYOBI service centre.
Using cleaning agent
Fill detergent tank with an appropriate cleaning agent. BY PULLING BACK THE nozzle hair on the lance, the device will
change to low-pressure operation and detergent will be added automatically.
Operating instructions
Purpose
The machine is designed to clean vehicles, machines, buildings, facades, etc. in the private sector.
Areas of application
• Never use the machine in potentially explosive areas under any circumstances!
• The operating temperature must be between 0℃ and +60℃.
• The machine consists of an assembly with a pump, which is encased in a shock absorbing housing. For an optimal working
position the machine comes with a lance and a non-slip handle grip, whose shape and configuration comply with the
applicable regulations.
• Do not cover or modify the lance or the spray nozzles in any way.
• The machine is designed to be used
with cold or lukewarm (max. 60℃); higher temperatures can damage the
pump.
•
Do not use water that is dirty, gritty or contains any chemical products, as these could impair operation and
shorten the life of the machine.
Connection
1. Screw the high pressure hose onto the water outlet pipe and the spray handle by turning it clockwise. Prior to operating
the machine please ensure that the high pressure hose has been completely uncoiled. Whilst the machine is in operation
the hose MUST NOT loop.
2. Check that the filter is mounted in the water inlet and that it is not blocked up.
3. The inlet filter must always be fitted in the water inlet to filter out sand, limestone and other impurities, as they will damage
the pump valves.
CAUTION: Failure to fit the filter will invalidate the guarantee.
4. Screw the water inlet connector onto the water inlet.
5. Insert the lance into the spray handle and turn it to lock it. Make sure that the spray handle is locked in the OFF position
by pulling out the locking lever and locating it on the tab in the handle grip.
6. Mount the nozzle or any other equipment you want to use.
7. Connect the water inlet hose (min. hose diameter 13mm) to the water tap and machine! Ask your local plumber about this.
8. Connect the machine to power supplies.
Starting up
1. Open the water inlet. Press the safety lock on the spray handle and pull back the trigger lever in order to bleed the
trapped air out of the device.
2. Turn on the switch on the device.
3. To temporarily turn off, release the trigger lever, at which point the device goes to standby. As soon as you press the
trigger lever again, the machine restarts.
4. To completely turn off the machine, press the ON/OFF switch on the device.
5. The shape of the water jet can be changed from concentrated to flat jet by turning the nozzle.
6. Using the lance with rotating nozzle is particularly effective in cases of very stubborn dirt.