Ryobi 3381160, Оригинальное руководство пользователя

Страница: 25 / 28

21
TROUBLESHOOTING
Problem Possible causes Solution
Machine does not start Drained battery Charge the battery.
Deffective battery Replace with compatible battery pack.
Fuse has blown Bring the product to an authorized service centre for service or repair.
Fluctuating pressure Pump is sucking air Check that hoses and connections are air tight.
Valves are dirty, worn out, or stuck Clean and replace the part or refer to a local distributor.
Pump seals worn out Clean and replace the part or refer to a local distributor.
Motor busses Low voltage or low temperature Activate the trigger of the spay handle.
Machine stops Fuse has blown Bring the product to an authorized service centre for service or repair.
Drained battery Charge the battery.
Thermal sensor activated Leave the pressure washer for 15 minutes to cool down.
Nozzle partially blocked Clean the nozzle.
Fuse blows Fuse too small Bring the product to an authorized service centre for replacement.
Machine pulsating Air in inlet hose/pump Allow the product to run with open trigger until regular working
pressure resumes.
Inadequate supply of mains water Check that the water supply corresponds to the specifications required
(see model tag). Avoid using long, thin hoses.
Nozzle partially blocked Clean the nozzle.
Water filter blocked Clean the filter.
Hose kinked Straighten out hose.
Machine often starts
and stops by itself
Pump/spray handle is leaking Contact your nearest authorized service centre.
Machine starts, but no
water comes out
Pump, hoses, or other accessory is
frozen
Wait for the pump, hoses, or other accessory to thaw.
No water supply Connect the water inlet port to a power supply.
Water filter blocked Clean the filter.
Nozzle blocked Clean the nozzle.