6) Route the sensor wires through the bumper to a suitable location in the
vehicle cabin or rear hatch.
7) RED wire of the main harness to connect to ignition wire (12-volt +) ACC.
8) BLACK wire of the main harness to be connected to a stable ground.
9) BRAKE wire (GREEN) to be connected to a positive charge wire of the
vehicle brake light to activate the front sensors.
10) After routing and attaching the cables, use an offal (small block of wood, etc) to
press the sensors into place.
NEVER push the sensor heads (center portion) to
push into the bumper.
5. Detecting Ranges
The front two sensors’ detection range is 4-feet. It is pre-adjusted for detecting
distances to a vehicle next to you while exiting from and entering into a parking
space to avoid scratching your vehicle. The sensors are activated while pressing on
the foot brake pedal and remain activated for 22-second after releasing the pedal.
6. Technical Support Contact Info
If you have other questions about the
RYDEEN Parking Sensor Products
, please
contact your retailer or Technical Support:
•
Telephone:
1-877-777-8811 (within USA only)
•
Email:
•
Web Address:
www.rydeenmobile.com
•
Important!
Do not use the negative charge wire of the vehicle back-up light for
ground. Some vehicles have a “check bulb” feature that makes that wire
not a true ground.
The system may not detect a small and round pole (such as a fire hydrant
or light pole, etc).
When the vehicle approaches a rising slope, the slope may not be
detected, as most of the signal will be reflected up and not back at the
vehicle.
5
Front
