RW Flame 46S32-BLACK, Руководство по сборке, Страница: 14 / 16

滚GLASS 滚长江东逝水
14
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE SOLUTION
Low heat / Low flame
when valve turned to
high.
Incorrect lighting operation. Ensure e ligh h t t ing procedure is followed carefully.
equalize. See lighting instructions.
Pipe must be sized according to installation code.
Burners burn with yellow
flame, accompanied by
the smell of gas.
Possible cobwebs or other debris. Thoroughly clean the burner venturi. See general
maintenance instructions.
Burners will not light with
the igniter, but will light
with a match.
Loose electrode wire or switch
terminal wires.
Check whether the electrode wire is firmly pushed onto the
terminal on the back of the igniter. Check that the lead
wires from the module to the ignition switch (if equipped)
are firmly pushed onto their respective terminals.
Knob not being held in long eno
Too windy.
Lava glass
or debris in ignition
area of the burner preventing
thermocouple from being fully
engulfed in flame.
Dirty thermocouple or thermocouple
connection.
Faulty thermocouple or valve.
Thermocouple mush have time to heat up - hold the knob in
for 30 seconds after the burner lights, then release.
If the wind speed is greater than 10 mph (16 km/h), the unit
will shut down automatically. Either place it in a different
area or use it when the wind is low.
the
Ensure that there are no lava glass or other debris in
the ignition area, and that the small hole below the
thermocouple is unobstructed.
Clean the thermocouple and clean the connection between
the valve and thermocouple. Ensure the connection is
properly tightened.
Replace thermocouple and / or valve.
Humming regulator. Normal occurrence on hot days.
This is not a defect. It is caused by internal vibrations in the
regulator and does not affect the performance or safety of
the appliance.
Humming regulators will not be replaced.
Burner output on "high"
setting is too low.
(Rumbling noise and
fluttering blue flame at
burner surface.)
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Cobwebs or other substances
in
the venturi tube.
Propane regulator in "low flow”
state.
Check gas level in
the
propane cylinder.
Reposition the supply hose to suit needs.
Clean burner orifice.
Clean out venturi tube.
Ensure
the
lighting procedure is followed carefully. All
valves must be in the off position when the tank valve is
turned on. Turn the tank on slowly to allow pressure to
equalize. See lighting instructions.
1
turned on. Turn the tank on slowly to allow the pressure to
The valve must be in the off position when the tank valve is
Burners will not stay lit
when control knob is
released.
ugh.
the
the