Overview of the remote keys
Key
Press
Description
A
Press 1x
System will arm in normal mode
B
Press 1x
System will arm in Silent mode
C
Press 1x
System will arm in Night mode
D
Press 1x
System will disarm, all strobes / sirens off and reset
D
Press 3x within 10 seconds when alarm off
Enter system Programming mode
Arming the system
When key “A”, “B” or “C” is pressed to turn the alarm on the control system then reads all of the sensors that are in
Active mode. If the sensors are OK then the system will arm, there will be a short strobe flash for 1 second and a short
audible beep from the control unit to indicate that the system is armed.
If a sensor is not OK then the system will not arm. A long strobe flash and long audible beep from the control unit (2
seconds) will indicate the failure to arm. The system panel will show the zone that had failed so the user can rectify the
situation and try again.
3x Arming Modes
1. Normal Mode
Pressing “A” arms the system in normal mode. Any activation in this mode will activate the strobe and sound
the siren.
2. Silent Mode
Pressing “B” arms the system in Silent Mode. Any activation in this mode will not sound the siren but will
activate the strobe.
3. Night Mode
Pressing “C” arms the system in Night Mode. When in Night Mode, the PIR is isolated so moving about in your
Motor Home at night will not set off the alarm. There is effectively a “perimeter” armed with the other
sensors active. If the alarm is activated in this mode the strobe will be activated but the siren will not. Instead
there will be a repeated 3x beep sequence that will sound.
Disarming the System
Pressing “D” will disarm the system. If the system has been in alarm then entering programming mode after a disarm
will show what sensor caused the alarm.
Key features of Operation when in Alarm
Siren
•
When alarm activated the siren will sound for 15 seconds then reset. If activated again, siren will sound for
another 15 seconds then reset. There is a maximum of 3x siren activation's then the siren will not resound.
When the alarm is disarmed the number of activation's will reset.
Strobe
•
When alarm activated the strobe will run for 60 seconds then it will go into power save mode, this will mean
it is on for 1 second and off for 3 seconds. When the alarm is disarmed the strobe power save feature will
reset.
Emergency (Panic) Switch
The system is equipped with a Panic switch. The operation of this can be set to respond in three different ways (see
programming). This operates independently of the system arm/disarm state ie it will work if the system is either armed
rvsecure.com.au
Made in Australia
