RVS RVS-7706035, Инструкция по эксплуатации

Страница: 9 / 22

Rear View Safety, 1797 Atlantic Ave., Brooklyn NY 11233
800.764.1028 sales@rearviewsafety.com
www.rearviewsafety.com
9
The Power Harness
• To power the system connect the power (RED) 12V+ wire to ignition power and
the ground (BLACK) wire to chassis ground.
• These are the only wires needed to power the entire system and all the
cameras. Each camera can be seen at any time by simply pressing the power
button and using the V1/2 button to toggle.
• The three positive trigger wires (WHITE-CH1, BROWN-CH2, BLUE-CH3) each
represent one channel and will turn on their channel when the trigger wire
is energized with 12V.
• "Camera 3" is the designated backup channel. To have the the backup camera
come on when you go into reverse, connect the BLUE wire to reverse
power (or any power source that comes on only in reverse).
• The other channels can similarly be triggered (i.e. side cameras can be
triggered by the turn signals etc.)
• To automatically have camera and monitor turn ON when vehicle activates,
simply twist BLUE positive trigger 12V+ to Red Power line 12V+ and wire to
ignition power.
Note: This setup will disable the menu in channel 3.
To access the menu simply move to channel 1 or 2 and
all the changes will apply to channel 3.
Note: When the blue wire is active it will have
precedence over the other triggers. Therefore, if you
wish to use multiple triggers, do not attach the blue
trigger to constant power.
WIRING CAMERA AND MONITOR