2
Closet 300 PS Unit
Installation, Usage and Maintenance Instructions
Thank you for selecting an RVR Energy Technology product. This product is the result of extensive research and experi-
ence in water pressurisation. This manual is an integral part of the product and should be retained. Please read it careful-
ly, as it provides important information regarding the installation and maintenance of the product.
The product should only be installed and maintained by a person qualified in the design and installation of
water pressurisation systems. Failure to properly install or maintain the product may lead to injury, death or
property damage.
01. INTRODUCTION
This document contains instructions for the use and maintenance of the Closet 300 PS unit. The Closet 300 PS has been
designed to pump clean water not containing abrasive particles.
Before installing and using the Closet 300 PS, read the following instructions carefully. RVR Energy Technology declines
any responsibility in case of accidents or damage caused by improper use of the unit or due to negligence or lack of ob-
servance of the instructions contained in this booklet or use of the product under conditions outside of the rated specifica
-
tions.
The Closet 300 PS is suitable for the provision of a pressurised water supply in residences and commercial premises. It
contains the following:
A MULTI-IMPELLER SUBMERSIBLE PUMP which is suitable for use in appli-
cations with up to 40 start/stop cycles per hour. The pump is fitted with a
continuous duty asynchronous motor and thermal overload protection.
A PRESSURE CONTROLLER
which controls the starting and stopping of the
pump. It must be installed in a vertical position with the water inlet at the
bottom and the water outlet at the top. It starts the pump when the outlet
pressure falls below 1.2 bar and stops when the flow stops.
A 300 LITRE TANK INCLUDING FLOAT VALVE AND OVERFLOW. The tank
is manufactured from WRAS approved material and comes with recessed
handles for ease of lifting during installation.
PERFORMANCE
Flowrate (l/min)
10
20
30
40
50
60
70
80
Pressure (bar)
3.4
3.1
2.9
2.5
2.1
1.7
1.2
0.7
Remove the pump
assembly from the
packaging
Insert the pump assembly
into the tank via the top
mounting hole
Ensure that the top plate
is sitting correctly within
the vibration isolating
insulation
Read these instructions
thoroughly before
installing the unit
02. ASSEMBLY
