E - 5
4. ADJUSTING THE SYSTEM MENU
(Cont’d)
SEEK DX/LOCAL
CLOCK ( Set the Current Time)
CLOCK 24H / 12H
BEEP ON/OFF (Beep Tone)
This feature is used to designate the strength of the signals at which
the radio will stop during automatic tuning. "DISTANT" is the default,
allowing the radio to tune to a broader range of signals. To set the unit
to select only strong local stations during automatic tuning, rotate the
Encoder Volume Knob until “LOCAL” appears on the display.
The
time
on
the
clock will default to 12:00 when power is
connected to the unit. To set the current
time, rotate the Encoder
Volume Control clockwise to adjust minutes
and
counter
clockwise
Rotate the Encoder Volume Knob to select your preferred clock format:
12H or 24H.
The beep tone feature allows the selection of an audible beep tone to be heard
each time a button is pressed on the face of the radio. "Beep Tone On" is the
default setting. Rotate the Encoder Volume Knob to select the “Beep Tone Off”
AREA (Tuner Frequency Spacing)
This option allows the selection of the frequency spacing appropriate
for your area. “AUSTRALIA” is the default setting. Rotate the Encoder
Volume Knob to select the EUROPE, ASIA, MIDDLE EAST, AUSTRALIA,
RUSSIA, U.S.A, LATIN, JAPAN options.
BT MODE
Use this function to check if Bluetooth is connected or disconnected -
BT STATUS.
Rotate the Encoder Volume Knob to turn On/Off the TA (Traffic
Announcement) function. In TA On mode, if there is a trafifc
announcement, the unit switches to the tuner mode (regardless of the
current mode) and begins to broadcast the announcement on traffic
conditions. When the traffic announcement is over, it will return to the
previous mode. When TA Off, traffic announcements do not cut in.
CT ( RDS Clock Time ) ON / OFF
Use this to turn on or off the automatic RDS Clock Time function.
BAT (Voltage)
Select this function to check your battery/power supply voltage.
TA ON/OFF (Traffic Announcement)
In Radio mode, if no buttons or functions are operated for 30 seconds,
the LCD will revert to the Clock display, as this is more useful in an RV.
RV Clock Screen Saver
option.
to
adjust
the
hours.
You can reset the unit to its default setting.
The RESET button is located on the main unit (as shown in the diagram
below). Pressing it vertically with a ballpoint pen or thin metal object will
reset the unit to it’s default factory settings.
The reset button can be used in the
following circumstances:
1. Initial installation of the unit when all
wiring is completed.
2. The Function buttons do not operate correctly.
3. An Error symbol is displayed on the LCD screen.
RESETTING THE UNIT
