Rutenbeck Control IP 4, Руководство по эксплуатации

Страница: 10 / 20

10 Settings
Factory settings
You can replace the Control
IP 4 factory settings with your
own settings.
Proceed as follows to restore
the factory settings:
1. Disconnect the Control IP 4
from the 230 V mains
voltage.
2. Simultaneously press but-
tons 1 and 2 on the device
and re-connect the mains
voltage whilst holding the
buttons.
3. The LEDs for the outputs
flash after three seconds
and the factory settings are
loaded.
Settings
Buttons
Operating elements
LEDs
The Control IP 4 outputs can
be switched via the buttons
located directly on the device,
the installed buttons or via the
Control IP 4 website.
1-4:
Switches the connected
device on/off; restores the
factory settings (see above)
1-4:
Switching state of the
device (illuminated when
switched on)
Link: Link state (illuminated in
the event of a network
connection)
Act: Activity (flashes when the
Control IP 4 web interface
is being called up)