Russound KLK-E5 Installation Manual
9
VOL
VOL
HOME
MENU
Double-gang wall box
KLK-E5 keypad
Cover plate
KLK-E5 INSTALLATION
For best viewing and usage, the KLK-E5 should
be mounted at thermostat height, or about 59” from
the floor.
To install a double-gang keypad, you will need a
UL/CSA approved plastic 32ci double-gang wall
box. Attach the box to the wall with appropriate
fasteners.
For installations employing a retrofit box or P-ring,
the two metal spacers on the back of the keypad’s
bezel can be removed for a better fit.
Route CAT-5 wire to the wall box from the
controller. There should be not more than 250 feet of
CAT-5 cable between the keypad and the controller.
Terminate the CAT-5 cable with an RJ45 connector,
using the T568A wiring standard. Insert the RJ45
connector into the jack marked “Controller” on the
back of the keypad.
Mount the keypad in the wall box and attach the
cover plate. Repeat the steps until all keypads are
installed.
CAUTION:
Mounting screws must be hand-tightened.
Over-tightening the mounting screws can cause
the touch ring and hard buttons to jam and
malfunction.
