Russound Acclaim 5C51, Руководство по установке

Страница: 7 / 16

7 Russound Acclaim 5 Series In-ceiling Loudspeaker Installation Manual
InStAllAtIon
Installation
Remove the grille from the speaker, if applicable. Use the clamp (dog-ear) 1.
to push the grille out from the back side.
Connect the speaker wire to the speaker terminals:
2.
Leave about 2' (60 cm) of wire extending through the ceiling cutout. •
Pull the conductors apart so the last two inches are separated and •
remove 1/2" (1.3 cm) of insulation from the end of each conductor.
Twist the strands in each conductor into tight spirals.
•
Attach the speaker wires to the red and black speaker terminals. Connect •
the Positive (+) conductor to the Red terminal and the Negative (-)
conductor to the Black terminal. Make sure that no stray strands of wire
are touching the other conductor or terminal.
Single point speakers have four terminals; Right(+), (-) and Left(+), (-). Run
•
an extra pair of conductors and observe proper polarity when making
connections.
Insertion of speaker wire on back of speaker baffle
(+)
(-)
Connect a safety wire from the building structure to the speaker frame 3.
or through the speaker basket. It should not interfere with the speaker
operation.
Safety wire
Attach Safety Wire
Center the frame in the cutout. Tighten the screws equally until the clamps 4.
secure the frame. Do not overtighten.
Install Speaker Frame
Speaker
As screws are tightened
clamp will rotate out and
snug against the drywall.
Cutout
Screws
Speaker Cable
Safety wire