9
Russound Acclaim 5 Series In-wall Loudspeaker Installation Manual
InStAllAtIon
Installation
Remove the grille from the speaker, if applicable. Use the clamp (dog-ear)
1.
to push the grille out from the back side.
The speakers have a location (the Russound Logo) that can be drilled out
2.
for placement of an remote IR receiver (ex. Russound 862 Eye). Refer to the
detail below. Drill from the rear of the baffle , not from the front.
Connect the speaker wire to the speaker terminals:
3.
Leave about 1' (30.5 cm) of wire extending through the cutout.
•
Pull the conductors apart so the last two inches are separated and
•
remove 1/2" (1.3 cm) of insulation from the end of each conductor.
Twist the strands in each conductor into tight spirals.
•
Attach the speaker wires to the red and black speaker terminals.
•
Connect the Positive (+) conductor to the Red terminal and the Negative
(-) conductor to the Black terminal. Make sure that no stray strands of
wire are touching the other conductor or terminal.
Decide whether the tweeter placement is more at ear level with the
4.
tweeter positioned at the top or bottom.
Level and center the speaker in the cutout. Tighten the screws equally until
5.
the clamps secure the frame. Do not overtighten.
Insertion of speaker wire on back of speaker baffle
(+)
(-)
As screws are tightened
clamp will rotate out and
snug against the drywall.
Install Speaker Frame
Cutout
Screws
Speaker Cable
Speaker
IR Receiver
Russound Logo
Speaker
IR Receiver Installation
Drill out the Russound Logo
from the back of the baffle
with a 1/2" (13mm) bit
