Russell Hobbs RHDW14SS, Инструкция по эксплуатации

Страница: 15 / 24

When the wo rking cycle has fi nished, the buzzer of the dishwasher will soun d for 8 seconds, then stop. Turn off
t he appliance using the ON/OFF button, shut off the wa ter supp ly and open the door of the dishwashe r.
Wait for a few minutes bef ore unlo ading th e dishwasher to avoid ha ndlin g the dishes and utensils while th ey
are still hot and more susceptible to break age. The y will also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
The program light is on but is not blinking, only in this case the programme has ended.
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door
After the spray arms stop working, you can open the door
completely. 2
3
Open the door a little .
1 4
5
The dishwasher will run after 10 seconds.
Wash th e arms in soapy and warm water and u se a soft brush to
clean the jets. Replace th em after rinsing them thoroughly.
When following this procedure from step1 to step 3, the filter system will be removed;
when following it from Step 3 to Step 1, the filter system will be installed.
It is dangero us to open the do or when was hing, because the hot water may s cald you.
If you open the door , the machine will pause. The program light will
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
dur ing a wash cycle
Premise:
A cycle that is underway can on ly be modified if it has only been running for a short time. Otherwise, the
detergent may have already be en released, a nd the appliance may have already drained the wash water.
If this is the case , the detergent dispenser mu st be refilled (see the section entitled " Loading the
Detergent " ).
Then you can change the program to the desired cycle setting,
(see the section en titled " Starting a wash cycle. . ." ).
Press the Start/Pause Button to stop washing , Then pres s programme butto n after 3 seconds , the programme will cancel
Pre ss the Start/Pause Button, the dishwasher will run
after 10 seconds.
1
2
When you press the Start/Pause button to pause during washing, the will
stop blinking and the dishwasher will mooing every minute unless you press the
Start/Pause button to start.
running indicator
If your model has broken remember function, the machine will go on to finish the selected
program
. after the power c ut