ASSEMBLE
1. Unpack the Castor Wheels and Arc-shaped Brackets from the product packaging.
2. Turn the heater upside-down on a scratch-free and stable surface to prevent damage to the paint
finish or your floor surfacing.
3. Fit the two (2) Castor Wheels onto the heater by placing the Arc-shaped Brackets between the
outermost fins on each side of the heater.
4. Securely fasten the two (2) Castor Wheels onto the heater by screwing two (2) Wing Nuts onto
each Foot.
5. Turn the heater in upright position after the Castor Wheel Assembly fitted. For the correct upright
position, please refer to fig. below
OPERATE
This heater is equipped with Electronic
Digital Controls that provide the ability to set the temperature
to the exact degree desired .To operate, simply follow these instructions.
NOTE: The temperature display will not reflect the accurate room temperature until the heater
has been operating for at least 20 minutes.
1. Turn on Power Switch, Press the power button once to start the heater on High Power (
),
Continuous Run.
If left at this setting , the unit will run continuously on High Power and will
not shut off until the unit is manually turned off or
the room temperature
over 30̊ C
.
2. Press the power button again to change to Middle Power (
), Continuous Run.
If left at this
setting, the unit will run continuously on Middle Power and will not shut off until the unit is
manually turned off or
the room temperature over
30̊ C.
3. Press the power button again to change to Lower Power ( ), Continuous Run.
If left at this
setting, the unit will run continuously on Lower Power and will not shut off until the unit is
manually turned off or
the room temperature over
30̊ C.
4. Press the power button a fourth time to turn the heater OFF.
: The heater
will run continuously if not setting temperature.
: If operated at the Low setting, the heater will not provide as much heat output as in the High
setting , however , the Low setting will not require a much electrical current to operate .To avoid
overloading a circuit , do not plug the heater into a circuit that already has other appliances working.
: Only operate the heater in normal
upright position with Castor Wheel
Assemblies attached to the bottom of the
unit (wheels on the bottom, controls on the
top), any other position could create a
hazardous situation
