use any abrasive or descaling agents to clean the iron.
STORING THE APPLIANCE
Complete Cleaning and Maintenance as instructed above.
Ensure that the steam knob is set to the
“0”/ “no steam”/ “OFF”
position.
Ensure that all parts are dry before storing.
Store only once the iron has cooled completely.
Store the appliance vertically in its box or in a clean, dry place.
Never store the appliance while it is still wet or dirty.
Never wrap the power cord around the appliance.
TROUBLE-SHOOTING
Problem
Possible Reasons
Solution
Not enough heat or too
much heat
The temperature dial may have
been rotated improperly.
The temperature dial may have
been set to the incorrect position
The iron is unplugged.
Set the temperature dial
to the correct position and
check
if
the
iron
is
plugged into the mains
power supply.
No steam is being produced
or leakage.
The temperature dial has been
set to
“0”/ “OFF”/ “MIN”
.
Set the temperature dial
to the required positioin.
No burst of steam or no
vertical steam.
The (vertical) burst of steam
function has been used too often
within a very short period.
The iron is not hot enough.
Continue ironing in a
horizontal position and
wait a few minutes before
using the (vertical) burst
of steam function again.
Leaking
water
from
soleplate.
Set the temperature dial so that it
is not within the steam range.
Set the temperature dial
as per steam range.
There is still not enough heat
being produced.
Use the steam button only
after the indicator light
has turned off.
The water is over the max
position.
Pour out the remaining
water.
Little Steam
Check if the steam knob is in the Set the steam knob to the
