Russell Hobbs 23300, Инструкция по эксплуатации

Страница: 6 / 8

6
AFTER USE
1. Set the temperature control to
•
.
2. Unplug the stand.
3. Open the water inlet cover.
4.
Hold the iron over a sink, turn it upside down, and drain the water from the reservoir.
5. Sit the iron on the base and leave it to cool down completely.
6. When cold, wipe off any moisture, and close the water inlet cover.
7. Wipe outer surfaces with a damp cloth.
8. Remove spots from the soleplate with a little vinegar – take care not to scratch it.
SELF CLEAN
To avoid scale build up, use the self clean function at least monthly in normal water areas, more
often in hard water areas.
You’ll need a basin or a large bowl to catch the water coming out of the soleplate.
1. Fill the reservoir to the max mark.
2. Set the temperature control to max .
3. Sit the iron on the stand.
4. Plug in the stand and wait till the smart status light flashes green.
5. Hold the iron over the basin or bowl with the soleplate down.
6. Move the steam control past
n to
C
and hold it there.
7. Gently move the iron to and fro, over the basin or bowl.
8. Water and steam will wash scale and dust through the soleplate, and into the sink.
9. When water and steam stop coming from the soleplate, release the steam control.
10. Follow the steps under AFTER USE.
AUTO SHUT-OFF
1. If the iron is motionless for about 8 minutes it will switch off.
2. The smart status light will slowly pulse red.
3. To switch on again, lift it off the stand then return it and allow it to heat up again until the
smart status light flashes green.