7
50 Hold the filter with the rim at the bottom.
51 Hold the cover with the arrow down.
52 Lower the cover over the filter till the cover hides the pips on the filter.
53 There are pips on the inside of the cover – keep these away from the pips on the
filter. You may find it easier to fit the cover it you turn it to and fro while lowering it.
54 Turn the HEPA filter so the rim is at the top, lower it into the upside down bin, and
turn it clockwise to lock it in place.
55 Close the bin, turn it right-way-up, and push it into the cleaner, till the bin release
lever clicks into place, to secure it.
outlet filter
56 Push the lock down, then lift the cover off the cleaner.
57 Pull the outlet filter out of the cover.
58 If the filter looks a bit mucky, tap it over the newspaper, to dislodge the dirt.
59 If its very dirty, soak it in warm soapy water, swill it out under a running tap, to
remove all trace of soap, then let it air dry, till it’s completely dry, before refitting.
60 Put the filter into the rear of the cover – the white side of the filter should be towards
the cleaner.
61 Fit the lugs in the bottom of the cover into the slots in the cleaner, and push the top
of the cover into the cleaner, till it clicks into place.
cleaning
Switch the cleaner off and unplug it before cleaning.
Don’t put any part of the cleaner in a dishwasher.
Don’t use harsh or abrasive cleaning agents or solvents.
timing
• Clean the cleaner frequently. Basically, the better you look after it, the longer it’ll last.
Keep an eye on it as you use it, and examine the filters when you empty the bin. If
anything needs cleaning, do it there and then, don’t put it off, in case you forget.
• Wipe external surfaces with a damp cloth. A dab of washing-up liquid will remove
stubborn stains, but clean it off afterwards, or it may stain.
• Wipe the tools with a damp cloth, or hand wash in warm soapy water. Rinse to
remove any trace of soap, and air dry before using.
• Wipe the extendable tube and hose with a damp cloth. Again, you can use a dab of
washing-up liquid to remove any stubborn marks. Remove all trace of the washing-
up liquid, and check they’re dry before refitting. Don’t put them in water, you’ll
damage them.
• Hand wash the bin in warm soapy water. Use a washing-up cloth or a gentle sponge,
don’t use a hard sponge or scouring pad. Rinse to remove all trace of soap and air
dry. Don’t replace it till it’s fully dry.
blockages
No matter how careful you are, sooner or later you’ll block the cleaner.
don’t panic!
If the cleaner starts to get noisy and you start to lose suction, don’t worry, it’s not the
end of the world, you’ve probably just blocked it up.
1 Switch the cleaner off and unplug it.
Содержание 13760
Страница 2: ...2...
