Charging and Testing
Charging the robot mower:
First:
•
Place the robot mower in the docking station for charging, even
if the robot has been pre-charged at the factory.
Testing the docking station:
•
Connect the wire to the adaptor and after-
wards to the power outlet and the LED in-
dicator on the docking station is turned on.
Turn on the mower Power button and the LED
indicator flashes green every 1 second. When
the robot mower is installed into the docking station and it
starts charging, the LED indicator flashes green every 0.5 sec-
ond (faster).
•
When the robot is fully charged the robot indicator shows a
constant green light (1).
Note:
If robot LED still keeps flashing after a long-time charg-
ing (more than 3 hours), generally there is a poor charging
contact. It’s time to clean charging tentacles and copper sheets
of robot. We suggest to clean these charging parts once a
week with steel wool or fine emery paper.
•
Disconnect the IN-wire from the red clamp. The LED indicator
flashes a green light and the alarm starts beeping. After 30
seconds, the buzzer stops beeping, but the LED indicator still
flashes green. This is a way of tracing if there is a breakage on
the boundary wire.
•
Reconnect the IN-wire to the red clamp and the LED-indicator now shows a constant green light again (2).
2
1
The “IN” arrow on docking
station points towards the
working area.
9
•
The docking station is now ready to use.
Important: The adapter must always be stored in a dry place.
MANUAL ·
RURIS RXR1000/RXR1500
