5
1.5
Safety Information
The following information is provided to ensure safe operation of the device. Please read it carefully
before you start using the device!
All the associated (additional) equipment such as computers, batteries, sensors, etc.
shall meet the requirements of standard EN60950-1.
Do not disassemble the device. If the enclosure of the device is damaged, or the
insulation of the wires is damaged, disconnect the power supply cables from the power
supply source first.
All wireless data transferring equipment produces interference that may affect other
devices placed nearby.
The device can be installed or dismounted only by qualified personnel!
The device must be firmly fastened in a predefined location. The predefined location is
described in the installation instructions.
The configuration must be performed using a 2nd safety class computer (with an
autonomic power supply).
Make sure that the device is installed in a location where it will not be subjected to harsh
environmental conditions for extended time periods.
Any installation and/or handling during a lightning storm is prohibited.
Caution! If an incorrect type of battery is used for replacement, there is a high explosion
risk. Dispose of used batteries according to the environmental requirements.
For configuration use cables that were purchased from Ruptela. Ruptela is not
responsible for any harm or damage caused while using the wrong cables.
Switch off the vehicle ignition before disconnecting the device.
Install the device in a restricted access location, not accessible or visible to the driver.
This crossed-out wheelie bin symbol means that waste equipment should not be
disposed of with your other household waste. The product must be taken to separate
collection points at the product’s end
-of-life.
