Rupes LH232N, Оригинальная инструкция по эксплуатации и обслуживанию

Страница: 8 / 32

8
TYPE LH232N LH31N LH32EN
INSULATION CLASS II II II
ABSORBED POWER 1200 W 1200 W 1200 W
ELECTRONIC OVERLOAD PROTECTION NO NO YES
ELECTRONIC SPEED CONTROL NO NO YES
ROTATION RPM 1600÷3400 3400 1400÷3400
MECHANICAL SPEED CONTROL YES* NO NO
ABRASIVE DISC DIAMETER mm 178 178 178
BUFFER DIAMETER MAX mm 200 — —
SPINDLE THREAD M14 M14 M14
WEIGHT Kg 3,7 3,3 3,3
TECHNICAL DATA ENGLISH
GENERAL WARNINGS
The safety and accident prevention instructions are reported in
the “SAFETY INSTRUCTION” booklet which forms an integral part
of these documents. This OPERATING INSTRUCTIONS MANUAL
indicates the additional information required specifically for use
of the tool.
CORRECT USAGE
This tool is designed to be used as a polisher. Read all the
warnings, instructions, indications provided on drawings and
specifications supplied with this tool.
Failure to comply with all the
instructions provided below may cause electrical shocks, fires and/or
serious injuries.
This tool is not intended to be used for smoothing, metal
brushing and cutting operations.
The use of this tool for unintended
applications may cause hazards and injuries to people.
The tool must be used with accessories that have been
specifically designed or recommended by the manufacturer.
The
fixing of the accessory to the tool does not guarantee a safe
operation.
The rated speed of the accessories must be at least equivalent to
the maximum speed specified on the tool. Using the accessories
at speeds above the rated one, may cause them to break or be
projected into the air.
The external diameter and thickness of the accessories must
match the specifications of the tool.
Accessories with incorrect
dimensions cannot be adequately protected or controlled.
The configuration of accessories must match the tool. The use of
accessories that cannot be perfectly fitted on the tool may result in
imbalance, excessive vibrations and in the impossibility of controlling
the tool.
Do not use damaged accessories. Before use, inspect all the
accessories. Inspect the supporting pads and verify there are no
cracks, tears or excessive wear. If the tool or accessory has
fallen, verify that it is not damaged or install a new accessory.
After inspecting or installing an accessory, test the operation of
the tool at maximum speed and without load for one minute,
keeping at a safety distance.
If the accessories are damaged, they
will break during this test.
8
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and frequencies of different power values may
vary. Refer to the label technical specifications to the nominal values of the tool.
(*) The tool must be connected to a suitable dust extraction system (not supplied).
according to EPTA-Procedure 01/2003