RUNZEL FOR-900, Руководство пользователя

Страница: 15 / 34

15 Runzel FOR-900 Utmärkt Page of 34 Page of 34 Runzel FOR-900 Utmärkt
Runzel FOR-900 Utmärkt
15
• The steam iron is powerful to iron vertically- clothes, curtains,
overcoats, etc.
• IMPORTANT: When switching on the iron, keep knob in the
maximum steam output position.
• When you switch on the appliance, push 2 or 3 times the
steam delivery button before ironing.
• This will ensure a regular steam production when you start
ironing.
• WARNING: the iron-steam generator connecting hose may
become hot.
TOPPING UP WATER IN THE BOILER
• When the water in the boiler runs out, the “no water”
indicator light (8) comes on. To top up, proceed as follows.
• Turn off the boiler using the “boiler on/off” button (10).
• Discharge any residual steam by pressing the “steam output”
button (2).
• Turn the iron off by pressing the “iron on/off” button (11).
• Unplug the appliance from the mains. Wait several minutes for
it to cool.
• Slowly unscrew the boiler cap (5) and top up as indicated in
the paragraph “filling the boiler”.
• DRY IRONING
• Plug the appliance into the mains.
• Press the luminous “iron on/off” button (11) to power the
iron. The “iron hot” indicator light (4) will comes on.
• Position the “thermostat regulation knob” (3) in one of the
areas shown in (tab. A “ Regulation iron’s temperature) ,
according to the type of fabric to be ironed. For dry ironing,
do not use the steam control (2).
• N.B.: when the iron has reached the selected temperature,
the light (4) goes out.
EMPTYING BOILER TO REMOVE LIME (IF PROVIDED)
This maintenance should be carried out for every 15-20 liters of
water used. In the lower part of the boiler there is a plug (28 fig.T)
that guarantees the emptying of possible lime depo-sits that may
have formed during use. To do the emptying operation, the product
must be tur-ned off, cold and with the electrical plug removed
from the outlet. Shake the product without turning it over and put
it on the edge of a table. Remove the rubber plug . Use a 3mm
hexagonal wrench and after inserting it in the proper place on the
plug, turn it until it is partially unscrewed. Place a container nearby
before removing the plug from its place. Let the water out until it is
completely emptied and having finished this operation put the plug
back in its place and screw it in until it is completely closed. Refill the
boiler again.
HOW TO USE THE BOTTLE
The bottle has been specifically designed to allow correct and
easy filling of the boiler without spilling or dripping water. For
best use of the bottle please follow these instructions:
• Fill bottle up to the level desired.