Runco VIDEOXTREME VX-8D, Руководство по установке и эксплуатации

Страница: 59 / 108

Installation
Runco VX-8d Installation/Operation Manual 43
PRE
L
IMINAR
Y
Configure Len s Motor Trigger: CineWide with AutoScope maintains constant image
height independent of the aspect ratio, while using the full display resolution of the
projector. It accomplishes this by moving the anamorphic lens in front of the primary lens
when widescreen material is being viewed. When the viewer transitions back to 16:9 or
4:3 source material, the anamorphic lens moves out of the light path.
To configure the lens motor trigger on the DHD Controller for proper AutoScope
operation:
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. On the DHD Controller remote control or front panel, press MENU .
3. Select S ervice from the Main Menu and enter the Service Menu passcode.
4. Select Trigger s from the Service menu.
5. Assign the trigger output to which the lens motor is connected to the Cinema and
Virtual Cinema aspect ratios. This enables the lens motor to move the anamorphic
lens into position (in front of the primary lens) when either aspect ratio is selected.
6. Select the Cinema aspect ratio to move the anamorphic lens into position, if it isn’t
already. To do this, press
CINEMA on the DHD Controller remote control (Figure 2-5),
or press or repeatedly with no menus visible on-screen.
Adju s ting the Horizontal (X) Len s Po s ition:
1. Project a white field on the screen.
2. Loosen the Yaw/X-Adjustment Levers underneath the lens.
3. Slowly move the anamorphic lens into place (from right to left or vice versa) so that
there are no shadows on either side of the screen:
4. When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
You must enter a passcode to access the Service menu for the first
time after turning on the system.
Note
Too Far Right
Too Far Left
Correct position