Runco NLMP22109, Руководство по установке и эксплуатации, Страница: 20 / 88

6 Runco VX-22i Installation/Operation Manual
PRE
L
IMINAR
Y
2.2
V
X -22i Rear Panel
Figure 2-2 shows the VX-22i rear panel.
Figure 2-2. VX-22i Rear Panel
1. LAMP COVER
Remove this cover to access the lamp compartment.
2. VACUUM FLUORE S CENT DI S PLAY (VFD)
Can be used instead of the OSD. Displays currently-selected menu or – if no menu is
selected – the current source, input resolution and aspect ratio.
If an error condition occurs, a message
appears here indicating the cause:
3. RUN LED
– Lights blue to indicate that the projector is functioning normally.
– Flashes blue (one second on/one second off) to indicate an error condition.
– Flashes blue (one half-second on/one half-second off) for approximately 90 seconds
after the system is turned off.
4. I SS UE LED
Lights red to indicate an error condition.
Remove the screw to
pull off the lamp cover .
Remove the screw to
pull off the lamp cover.
L
L
SERVICE PORT
AUTHORIZED
PERSONNEL ONLY
WIRED REMOTE
WIRED REMOTE
HD2 (BNC)
HD1 (RCA)
HD1 (RCA)
HD2 (BNC)
HD3 (VGA / Y-Pb-Pr)
HD3 (VGA / Y -Pb-Pr)
Service port.
Not for user
access
10 2
3 1 5 7 9 11
12 4 6 8
13 14 15 16
Please check issue(s)
Communication Error