Runco FlPL-50XA, Руководство по эксплуатации для владельца

Страница: 52 / 68

Operation
42 Runco PlasmaWall Owner’s Operating Manual
PRE
L
IMINAR
Y
Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the DHD Controller and PlasmaWall will respond. By default,
both are set to 17. You can change these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the PlasmaWall remote control in ways that are unpredictable or undesirable.
• You have multiple PlasmaWall displays and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
display.
When you change a remote code on the DHD Controller, you must re-program your
remote control to send that same code. To do this:
1. Using a straightened paper clip or similar object, press and hold the CODE button on
the remote control for approximately three seconds, or until the red LED on the
remote lights solid red.
2. Enter a new two-digit code between 00 and 31 inclusive. Include a leading zero for
single-digit codes; for example, enter 9 as “09.”
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
Analog Out Mode: Select Analog Out Mode from the Service menu to change the
characteristics of the analog output signal from the DHD Controller. The choices are
RGB-- (separate sync with negative polarity), RGB++ (separate sync with positive polarity)
or RGBS (composite sync).
Display Device: The options in the Display Device menu allow you to perform certain
adjustments at the plasma display.
• Input Source: Select Input Source from the Display Device menu to switch from one
DHD output/PlasmaWall input to the other. To display the analog signal from the DHD
Controller, select RGB. To display the digital signal, select DVI/HDMI.
• Configure: Select Configure from the Display Device menu to perform the following
display device adjustments (these are global, independent of any input):
• Select Noise Reduction to apply noise reduction to the displayed image.
• Select Inverse to invert the colors in the displayed image. Use this for repairing
burned-in areas of the plasma display.
• Select Left/Right , Up/Down , Width or Height to to fine-tune the aspect ratio and
image position.
Use the front-panel keypad on the DHD Controller to change its IR
code. Then, change the code sent by the remote to match as
described below.
Tip