Start Up of the Adjustment Mode
5-1
5
START UP OF THE ADJUSTMENT MODE
Adjustment Mode
All picture geometry and convergence adjustments are made while in
the '
Adjustment Mode'. Press the ADJUST key to enter the 'Adjustment
Mode'.
You are now in the
'Adjustment mode'. The Control disk is used to
make menu selections and also vertical and horizontal adjustments.
The ENTER and EXIT keys are used to move forward and backward
through the menu structure. The ADJUST key can be used to
terminate the adjustment mode while any path selection menu is
displayed.
When an adjustment menu is displayed on the screen and no action
is taken within the first 5 minutes, the projector will automatically
reduce the brightness and contrast to a level so that the stationary
image cannot damage the tubes.
There are 6 possible paths to follow once in the
'Adjustment Mode.'
They are :
INSTALLATION - Installation should be selected if the projector has
been relocated and/or a different screen size is desired. When
selecting 'Installation', the user or operator will be warned to call a
qualified technician to perform the installation procedure (see exam-
ple of projected warning on the next page).
GUIDED - Guided should be selected if the user intends to perform a
complete alignment of the projected image. All of the necessary
geometry and convergence adjustments are made in a predeter-
mined sequence.
RANDOM ACCESS - Random Access should be selected if the user
intends to make only a few adjustments.
SERVICE - Service should be selected if the user intends to delete
blocks, change password, select service adjustments, or get set-up
information.
EYE-Q - This selection will access the EYE-Q menu.
While in Guided or Random Access Adjustment Modes, the user may
use an external source, an internally generated genlocked pattern, or
an internally generated multifrequency cross hatch pattern as a setup
pattern.
Warning during the start up of the installation mode
Some items in the Adjustment Mode are password protected. While
selecting such an item, the projector asks you to enter your password.
(Password protection is only available when the password DIP switch
on the controller module is in the ON position. Contact a Runco
authorized technician when no password is requested during the
adjustment procedure and password protection is desired.)
Your password contains 4 digits.
Enter the digits with the numeric keys on the RCU.
Example: 2 3 1 9
For each digit entered, a 'X' will appear on the screen under the
displayed text '
enter password'. When your password is correct, you
will have access to the 'Adjustment item'. When the entered password
is wrong, the message
'Wrong password !!!' will be displayed. The
projector will stay on the previously selected item.
Factory programmed password:
0000
Once the password is correctly entered, all other password protected
items are accessible without re-entering your password. When re-
entering the Adjustment Mode, it will be necessary to enter your
password again when selecting a password protected item.
SOURCE SELECTION - Provides the selection of either RGB,
Component, RGB Tri-level or Component Tri-level sources.
